8 Bit Flip Flop QUAD 20 Pins * Series
T flip flop is configured with an output of TTL. This trigger is configured to use POSITIVE EDGE. This type of FPGA is a part of the * series. A total of 1elements are present in it. It belongs to the family of electronic devices known as ALS. There is an electronic part that is mounted in the way of Surface Mount. The 20pins are designed into the board. This device exhibits a clock edge trigger type of Positive Edge. There is a Bus Driver/Transceiverbase part number assigned to the RS flip flops. It is designed with 8bits. As soon as Vsup reaches 5.5 V, the maximum supply voltage is reached. For normal operation, the supply voltage (Vsup) should be kept above 4.5 V. Considering its reliability, this T flip flop is well suited for TUBE. A total of 5 V power supplies are needed to run it. This flip flop has a total of 2ports. Optimal efficiency requires a supply voltage of 5 V. A -1 mAvalue is set for the high level output current. 12 mA is the low level output current. A temperature below 125 °Cis recommended for operation. It is recommended that the operating temperature be greater than -55 °C. Despite its minimal supply voltage of 4.5 V, it is capable of operating. 5.5 Vis the maximum supply voltage it supports. We are able to achieve a frequency of 28 MHz. The logic IC it uses is BUS DRIVER. As a result, it is equipped with 1 functions . This device is equipped with a pin count of 20.