20 Terminals 4.75 V ~ 5.25 V 20-Pin ISL6558 DC to DC converter IC SWITCHING CONTROLLER 4 Outputs 80kHz ~ 1.5MHz PWM Signal

This switching controller fits most application requirements since it is packaged in a VQFN package. 4 outputs can be generated with the dc motor controller. PMIC is packaged in a solid enclosure of Tape & Reel (TR). PWM Signal dc switching's outputs (s) are supported. 4.75 V ~ 5.25 V is the operating voltage and supply voltage of the dc control. Suitable for a 0°C ~ 70°C (TA) dc switcher. There is a switch at 80kHz ~ 1.5MHz that can be used with this controller. Enable, Frequency Control, Power Good is used for efficient switching control in the dcdc regulator. An analog IC SWITCHING CONTROLLER is connected to the switch converters. The switching converters's terminal (s) are designed at QUAD . A variety of terminations with 20 of dc switching. It includes PULSE WIDTH MODULATION as one of the control techniques dc dc converter ic adapts. DC switcher's input voltageis set to 5V. You can find other relevant dc to dc converter ics by searching "ISL6558". There are only 20 pins on switching converter. Having a Surface Mount makes DC switcher ideal for most prototype and application designs. The value of DC to DC voltage regulator is set to ALSO OPERATES IN CURRENT MODE in order to better satisfy the requirement. In order to run the voltage regulator dc to dc safely and reliably, users are advised to apply 5.25V. A temperature of 0°C or higher is recommended. A temperature of 70°C degrees Celsius is recommended. Thare are switch converters of the -- series. A total of 1 functions are present in the switch converters. When the dc switching is dormant, it uses 50μA. A maximum frequency of 1.5MHz can be set by the controller. With 120A input, it is ideal for switching controllers. It would be 20-QFN-EP (5x5) for this part's supplier dc dc controller package. In normal operation, it outputs 5V. The top frequency at which this switching controller can switch is 1500kHz.