1nA 98 dB Instrumentational OP Amps 0.008μA 2V~44V ±1V~22V LT1490 8 Pins 8-SOIC (0.154, 3.90mm Width)
Packaging for the buffer amplifier is in the form of a 8-SOIC (0.154, 3.90mm Width) case. A General Purpose-type buffer amplifier is shown here. There is a Tube case that is delivered with the instrumentation amplifiers. A total of 8 terminations have been reported in the past few weeks. Buffer amplifier has a total of 8 pins on it. I would like you to keep in mind that this buffer amplifier needs to be run at a voltage of 15V. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. The buffer amplifier functions well at -40°C~85°C as far as operating temperature is concerned. The buffer amp consists of 2 circuits in total. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Rail-to-Rail signals. A supply of 50μA or higher is recommended for use with this electronic part. The Over-The-Top® stands for the buffer op amp's serial number. There are a maximum of 50000 voltage gains that can be conducted by this operational amplifier at its minimum voltage gain.