16 Terminals 4.1V~15V 16-Pin LTC3703 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs 100kHz~600kHz Transistor Driver

This switching controller fits most application requirements since it is packaged in a 16-SSOP (0.154, 3.90mm Width) package. 1 outputs can be generated with the dc motor controller. PMIC is packaged in a solid enclosure of Tube. Transistor Driver dc switching's outputs (s) are supported. 4.1V~15V is the operating voltage and supply voltage of the dc control. Suitable for a -40°C~85°C TA dc switcher. There is a switch at 100kHz~600kHz that can be used with this controller. dc dc regulator is made easier with Surface Mount. Current Limit, Enable, Frequency Control, Soft Start is used for efficient switching control in the dcdc regulator. An analog IC SWITCHING CONTROLLER is connected to the switch converters. The switching converters's terminal (s) are designed at DUAL . A variety of terminations with 16 of dc switching. It includes PULSE WIDTH MODULATION as one of the control techniques dc dc converter ic adapts. DC switcher's input voltageis set to 5V. You can find other relevant dc to dc converter ics by searching "LTC3703". There are only 16 pins on switching converter. DC regulator outputs 60V voltage according to the test statistics. normally, the dc dc regulator's output current is 5A, which you should keep in mind when starting a project. DC regulator's maximum frequency is 330kHz. It is possible to set the input voltage to 60V for nominal working status. Users must limit the voltage accordingly because the dc switcher's maximum input voltage is 15V. The supply voltage must be 9.3V. As per its datasheet, the switching converter has a maximum output of 12V volts. Its lowest voltage output is not less than 800mV.