MC74ACT564DWR2G Overview

The flip flop is packaged in 20-SOIC (0.295, 7.50mm Width). Package Tape & Reel (TR)embeds it. As configured, the output uses Tri-State, Inverted. In the configuration of the trigger, Positive Edgeis used. There is an electrical part that is mounted in the way of Surface Mount. With a supply voltage of 4.5V~5.5V volts, it operates. It is operating at -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. FPGAs belonging to the 74ACTseries contain this type of chip. It should not exceed 85MHzin its output frequency. In total, there are 1 elements. There is a consumption of 8μAof quiescent energy. Currently, there are 20 terminations. The 74ACT564family includes it. The D flip flop is powered by a voltage of 5V . This JK flip flop has a 4.5pFfarad input capacitance. Devices in the ACTfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device has Positive Edgeas its clock edge trigger type. An electronic part designed with 8bits is used in this application. Its superior flexibility is attributed to its use of 8 circuits. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. It runs on 5Vvolts of power. A D flip flop with 2embedded ports is available. If high efficiency is desired, the supply voltage should be kept at 5V. It has 3 output lines to operate.

MC74ACT564DWR2G Features

Tape & Reel (TR) package
74ACT series
20 pins
8 Bits
5V power supplies

MC74ACT564DWR2G Applications

There are a lot of ON Semiconductor
MC74ACT564DWR2G Flip Flops applications.

• Bounce elimination switch
• Data storage
• Data transfer
• Latch
• Registers
• Memory
• Frequency division
• Memory
• Event Detectors
• Data Synchronizers