2V~6V 35MHz 8 Bit D-Type Flip Flop DUAL 74HC374 20 Pins 4μA 74HC Series 20-DIP (0.300, 7.62mm)

20-DIP (0.300, 7.62mm)is the packaging method. The Tubepackage contains it. T flip flop is configured with an output of Tri-State, Non-Inverted. This trigger is configured to use Positive Edge. In this case, the electronic component is mounted in the way of Through Hole. The JK flip flop operates with an input voltage of 2V~6V volts. In the operating environment, the temperature is -55°C~125°C TA. It is an electronic flip flop with the type D-Type. This type of FPGA is a part of the 74HC series. This D flip flop should not have a frequency greater than 35MHz. A total of 1elements are present in it. There is 4μA quiescent consumption. A total of 20terminations have been recorded. The 74HC374 family contains it. A voltage of 3V provides power to the D latch. This T flip flop has a capacitance of 10pF farads at the input. It belongs to the family of electronic devices known as HC/UH. There is an electronic part that is mounted in the way of Through Hole. The 20pins are designed into the board. This device exhibits a clock edge trigger type of Positive Edge. It is designed with 8bits. As soon as Vsup reaches 6V, the maximum supply voltage is reached. For normal operation, the supply voltage (Vsup) should be kept above 2V. The superior flexibility of this circuit is achieved by using 8 circuits. A total of 2/6V power supplies are needed to run it. This flip flop has a total of 2ports. This T flip flop features a maximum design flexibility due to its output current of 7.8mA. In order for the chip to function, it has 3output lines.