SPDT 100Ohm Analog Switches BREAK-BEFORE-MAKE 74HC4053 16 Pins 100nA 4.5V 16-SOIC (0.154, 3.90mm Width)

As the electronic part is packed in 16-SOIC (0.154, 3.90mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 2:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -55°C~125°C TA. Total terminations are 16. The electronic part provides high-quality output because it has 2 channels. Powered by a 4.5V voltage supply, the electrical part should be switched on and run. The electrical component body receives 16 pins. Circuits based on SPDT switching are used to construct these analog switch ics. There are 3 circuits in this switch device. Try searching with 74HC4053 to find analog multiplexer variants. An switch multiplexer with 190Ohm internal resistance has a value of 190Ohm. Datasheets for 16 pin functions are available upon request. Multiplexers should not be powered above 6V in normal situations. The analog switch ic is of the Dual, Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 2V. An operating current of 40μA would be sufficient for this switch device. Despite this switch device's dual supply capability, its voltage should not exceed 6V. It is recommended that you attach at least 1V to your dual power supply. An analog IC with the number SINGLE-ENDED MULTIPLEXER is integrated into this board. Operating the 6 inputs requires 6 inputs. There are 120MHz bandwidths for data transfer.