N-Channel 1.27 mm PMIC MM8™ Series MIC2075 8 Pin 8-SOIC (0.154, 3.90mm Width)
It is packaged in the form of a Tape & Reel (TR).It is included with the 8-SOIC (0.154, 3.90mm Width) package as well.A Surface Mount mounting is used for the LED driving board.The switch type of this switch is General Purpose.To ensure reliable performance, the temperature should be set to -40°C~85°C TA.The lighting driver has a total of 1 outputs that are available for use.With a supply voltage of Not Required, the LED driving board operates.A maximum output voltage of N-Channel volts can be obtained with this LED driver.There are Slew Rate Controlled, Status Flag features available on the LED driving board.As you can see, it comes from the MIC2075 family.During operation, the 8 pins are used.It is important to note that the LED driving board has 1 functions.From the lighting driver, there is a maximum output of 500mAV.To comply with the operation criteria, the maximum output current is reduced to 500mA.Surface Mount is mounted in the way of this LED driving board.In this case, there is 140MOhm resistance in the LED driving board.It is included in the MM8™ series.This results in a 500 mA output current.The LED driver is packaged in an econtainer with a capacity of Switch ICs.The maximum supply voltage for this lighting driver is set to 5.5 V (Vsup).In order to operate normally, the supply voltage (Vsup) must remain above 2.7 V.This LED driving board uses an analog IC POWER SUPPLY SUPPORT CIRCUIT.A total of 1 channels are available for you to choose from.For maximum efficiency, the supply voltage should be set to 2.7 V to 5.5 V.It is designed to be stable at 85°C°C, which is the maximum operating temperature.The LED driver must work at a minimum temperature of -40°C degrees Celsius in order to remain reliable.In this case, the electrical component is classified as High Side.