3V~40V 10-Pin MIC2174 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs 300kHz Transistor Driver
In the 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) package, the switching controller meets most application requirements. There is sufficient capacity to generate switching controller for outputs 1. There is a Tube solid enclosure around the pmic. With this function, you can deal with Transistor Driver dc switching's outputs (s). DC control operates at 3V~40V volts and has 3V~40V supply voltage. Suitable for working in an dc switcher that has a -40°C~125°C TJ. It can switch at 300kHz. As it has a Surface Mount value, it can be used for general dc dc regulator. To provide efficient switching control, Enable is included in the dcdc regulator. A SWITCHING CONTROLLER analog integrated circuit is connected to the switch converters. DUAL are the position of the terminal of the switching converters. This dc dc converter ic uses a variety of control techniques, including HYSTERETIC CURRENT MODE. In addition to "MIC2174", there are other relevant dc to dc converter ics you can find. There are 10 pins on switching converter. Specifically, switching converter falls under the Switching Regulator or Controllers category. DC regulator outputs 5.5V voltage based on test statistics. A starting point for a project is to note down the dc dc regulator's usual output current, which is 25A. Voltage regulator dc to dc is designed to operate at 87 % duty cycle during power-ups and power-downs to ensure reliability. Because of DC switcher's Surface Mount, it is suitable for most prototype designs and applications. DC regulator375kHz has the maximum frequency. A frequency of 300kHz is set for the switching controller. Hence, ALSO HAS ADJUSTABLE OUTPUT VOLTAGE DOWN TO 0.8V is used to better suit the DC to DC voltage regulator's situation. You should keep dc regulator at -40°C degrees or higher. There should be 125°C temperature above 125°C degrees Celsius when dc regulator runs. The dc to dc voltage regulator is from the Hyper Speed Control® series. 1 functions (s) are included in the switch converters. Designing voltage regulators switchings with 10 pins. There would be 10-MSOP supplier dc dc controller package for this part. An output current greater than 25A cannot be provided by the dc switcher. 1.4mA volts is the supply current. During switching, this controller has a phase of 1. It is possible for this switching controller to switch at a frequency of 375 kHz. Voltage rating is 40V.