0.95 mm PMIC -- Series MIC2291 5 Pin 1.2MHz SOT-23-5 Thin, TSOT-23-5
Using its SOT-23-5 Thin, TSOT-23-5 package, it is possible to save board space. LED drivers design with 1 outputs.This mounting method is Surface Mount.The system emerges as a DC DC Regulator with high efficiency.It is capable of working normally at -40°C~125°C TJ.Camera Flash has considerable advantages.A frequency of 1.2MHz is used to operate it.This configuration is built upon 5 pins.It is possible that failures will occur if the voltage supply is below 2.5V.3 segments are present.The mount is in the way of Surface Mount.The LED driver is available under the part number MIC2291.There is no maximum value acceptable for the supply voltage, so 10V is acceptable.Its output voltage is --.The device has a pin count of 5.The voltage range of this device is optimized for a maximum supply voltage of 10V.In addition to Driver ICs, it is also classified by its characteristics.A minimal supply voltage of 2.5V is required for it to achieve the highest efficiency.The operating temperature should not exceed 125°C to ensure stable operation.1.2 A is the maximum amount of current that can be supplied to the load.It is necessary to maintain a higher operating temperature than -40°C in order to achieve stable operation.LED drivers belonging to the series -- are important components in a wide range of applications.IC LED DISPLAY DRIVER is used on this part as an interface IC.This device produces a voltage of 34V as its output.There shouldn't be an increase in output voltage over 34V.Transmissions are currently available on 1 Channel channels.