-- Fixed 2.31 mm MIC5200 PMIC -- Series 3 TO-261-4, TO-261AA

The package is delivered in a Tape & Reel (TR) case. In order to package the IC voltage regulator, a TO-261-4, TO-261AA case is used. On the Voltage regulator IC, there are 4 terminations that can be connected. This IC Regulator has a type of output called Fixed. There are 1 regulators implemented in this electroic component. Surface Mount can be adjusted in the Linear IC in order to vary the temperature range over which Linear Regulator operates. The IC voltage regulator must be maintained at -40°C~125°C degrees for it to function. As you can see, this regulator's output function is configured to be Positive. At present, it can produce an output of up to 100mA. As you can see, the regulator IC has a total of 3 pins. The regulator has a total of 1 outputs to make sure that it delivers prompt, sufficient outputs. A dropout voltage of 10 volts is what makes it a dropout voltage. Depending on the chip, 3 pins may be available. For your information, part number MIC5200 is the basic part number for this voltage regulator IC. As you can see, this regulator IC represents a typical PMIC - Power Management ICs component. As far as the regulator type, it is a FIXED POSITIVE SINGLE OUTPUT LDO REGULATOR type. There is a maximum output current of 100mA for this regulator to meet the operational requirements. It operates in the 10 nA Quiescent Current state. The -- Series is a series of products made by D-Link. In regards to tolerance, this voltage regulator IC has an 1 % tolerance, which is quite low.