6 Terminals 1.8V~6.5V 6-Pin TPS64200 DC to DC converter IC SWITCHING CONTROLLER 1 Outputs Transistor Driver

In the SOT-23-6 package, the switching controller meets most application requirements. There is sufficient capacity to generate switching controller for outputs 1. There is a Tape & Reel (TR) solid enclosure around the pmic. With this function, you can deal with Transistor Driver dc switching's outputs (s). DC control operates at 1.8V~6.5V volts and has 1.8V~6.5V supply voltage. Suitable for working in an dc switcher that has a -40°C~85°C TA. As it has a Surface Mount value, it can be used for general dc dc regulator. To provide efficient switching control, Enable is included in the dcdc regulator. A SWITCHING CONTROLLER analog integrated circuit is connected to the switch converters. DUAL are the position of the terminal of the switching converters. Various 6 terminations. There is a DC switcher's nominal voltage of 3.8V. In addition to "TPS64200", there are other relevant dc to dc converter ics you can find. There are 6 pins on switching converter. DC regulator outputs 6.5V voltage based on test statistics. A starting point for a project is to note down the dc dc regulator's usual output current, which is 3A. Voltage regulator dc to dc is designed to operate at 100 % duty cycle during power-ups and power-downs to ensure reliability. Because of DC switcher's Surface Mount, it is suitable for most prototype designs and applications. In order for the voltage regulator dc to dc to perform safely and reliably in a circuit, users are advised to apply 6.5V. In dormant mode, 20μA is used. It is possible to set the input voltage as 3.8V for nominal working statuses. Since the dc switcher's maximum input voltage is 6.5V, the voltage must be regulated accordingly. Voltage 1.8V must be supplied. Depending on the datasheet, the switching converter can output 6.5V volts at its peak. A voltage controller's lowest output voltage cannot be less than 1.8V. The frequency at which this controller can perform well is 350kHz.