6 Terminals 6-Pin DC to DC converter IC SWITCHING CONTROLLER

Capsuled in the SOT-23 package, the switching controller can be used for a wide range of applications. PMIC packaging is solid with a Tape & Reel (TR) enclosure. An analog IC with the SWITCHING CONTROLLER signal is connected to the switch converters. A switching converters's terminal (s) sits at the DUAL position. A variety of dc switching's functions can be performed on 6 terminations. DC switcher's voltage input is 3.8V. Pins number 6 of switching converter in total. As a result of this, the maximum duty cycle of the voltage regulator dc to dc must remain 100 % during power-up and power-down. Users should apply 6.5V to operate the voltage regulator dc to dc safely and reliably. At least -40°C°C is recommended. At85°C, dc regulator should run. 1 functions are available in total for the switch converters. A dc switching in a dormant state uses 20μA. We design voltage regulators switchings with 6 pins. The maximum input voltage of dc switcher is 6.5V, so users should limit their voltage accordingly. With 3A inputs, switching controller is ideal. It outputs a value of 6.5V in normaloperating procedures. Voltage 1.8V is needed for the supply. There will be 3A current output from the dc switcher above 3A. The datasheet indicates that the switching converter can output 6.5V volts at its maximum. 1.2V voltage output is lower than 1.2V. The phase of this controller is 1.